3.9. Reset
15
Reset In:
Use this
INPUT jack
when you want less than the maximum number of steps in a sequence. Just
patch the
Trig Out jack
of the last step in the sequence to the
RESET IN jack
. When the sequence reaches that
step, it will be reset and begin again at step 1.
3.10. Output Voltage Control
16
Range Switch ( +/-1V < > +/-5V ):
When you want to control synthesizer functions with a smaller voltage
range, use the +/-1V position.
17
LED's:
These light emitting diodes give visual confirmation of the channels and steps in a sequence.
18
Voltage Controlled Knobs:
These knobs are used to adjust the output voltage at each step in the sequence.
Put the mode selector in one of the stopped sequence mode, and then as you press the Step button adjust the
knobs one at a time to get the desired effect from the synthesizer to which the sequencer is connected.
3.11. Analog Mixer
19
Analog Mixer:
This lets you add DC voltages. For example, you could add channel A and Channel B so that
channel A is used for rough adjustment, and channel B is used for fine adjustment, so that you obtain a very
accurate output voltage setting. If you connect a number of sequencers in series, this lets you put them together
into a single output jack.
3.12. Power Switch
20
Power Switch:
After you turn on the switch and the lamp goes on,
wait ten minutes
for the sequencer to
warm up, then set the controls. This will assure you of reliable results.
7
Summary of Contents for SQ-10
Page 1: ...USER S MANUAL...
Page 2: ...2...
Page 11: ...6 3 Blank patch chart 11...
Page 12: ...7 SQ 101 Fold Out 12...
