3.5. Sequence
Mode
9
Mode Selector:
This 6 position control selects the type of sequence...stepped, continuous or one-time...for 12
or 24 step sequences.
sequence modes
3.6. Portamento
10
Portamento A, B:
Ordinarily the voltage changes in a sequence form a sharply stepped progression, but with
this knob you can make these changes smoother and get a portamento effect.
3.7. Duty
11
This adjusts the multiple trigger width as the steps advance. When you turn the knob all the way to the " "
position, the multiple trigger cuts off at each step.
3.8. Outputs
12
Channel A, B, C Voltage Out
: These are the
Output Voltage jacks
for each of the channels. However, when
channels A and B are in a series connection mode, the output mode will depend on the way they are connected.
Refer to the chart for details.
13
Multiple Trig Out:
This puts a trigger ( ) signal with each step in a sequence.
14
Trig Out:
These
OUTPUT jacks
provide independent output trigger signals for each step. If you connect a
patch cord from one of these outputs to the
RESET IN jack
, your sequence will go from step 1 to the
Trig Out
jack
you used. This procedure is used when you want a short sequence. Since only these jacks put out a
trigger signal when that step in a sequence is reached, you can use them to connect to a number of different
synthesizers to create complex rhythms.
6
Summary of Contents for SQ-10
Page 1: ...USER S MANUAL...
Page 2: ...2...
Page 11: ...6 3 Blank patch chart 11...
Page 12: ...7 SQ 101 Fold Out 12...
