3.
2.
3.
4.
3.
1.
4.
Installation instructions
57
Properties
• Simultaneous air input and output
• Automatic operation based on relative
air humidity in the room
• A possibility of using manual mode
• Electronically closeable flap of the air input/
output (available with the 1200 series)
• No condensation occurs inside the device
• Heat recovery
• Filtration of both air taken in and air taken out
• Low voltage of 12 V in the device
• Heat protection against overload in the
230 V power supply transformer
1.
Control elements
2.
Power supply by
KORADO, a.s.
3.
Air taken in
4.
Air taken out
In order to avoid personal injuries and damage to property strictly observe and comply with the
following:
• Connect the European-standard power plug on the connection cable only to an appropriate
walll socket of the AC 230 V mains.
• If the electric cord of this device is damaged, it must be replaced by a customer service com
-
pany or an expert having relevant qualification. Thus you will be able to avoid putting anybody
or anything in danger.
• If it is necessary to perform some work with connection to the AC 230 V mains, these may only
be performed by a specialized electrician.
• When fitting the power cord in the wall part of the installation, it is necessary to make sure all
pole power supply leads have been disconnected .
• When working with the electrical voltage distribution network or home installation network, it is
absolutely necessary to strictly comply with relevant regulations valid in a particular country.
• If a solid object or liquid penetrates the inside space of the device, stop operating it immediately
and disconnect it from the mains.
Symbols used
Notice!
This paragraph contains additional information and helpful tips.
