Kontron PCI-953, User Manual

Page: 155 / 158

Operating System (OS) Diagnostics 5-7 PCI-953 Single Board Computer User’s Guide
Troubl
eshooting
³
Operating System (OS)
Diagnostics
This section describes how to use the drivers for any Microsoft Windows-95/98/NT device. For
other operating systems, please refer to the OS manual/guidebook.
³
Booting
If
Windows 95/98/ME
hangs during loading and the Windows logo shows no progress or no
display is given, follow these steps:
1) Restart your system and press [F5] when the Windows system is loading to enter “Safe
mode”.
2) Once in “Safe mode,” remove any devices that are not running or installed properly.
3) Restart Windows. The devices that have been removed will be detected again. The
drivers will be loaded automatically if the drivers have been copied into the system
database, or you will be asked to provide a driver source for installation.
For
Windows-NT 4.0
users, it is not always recommended that you change your hardware
configuration after your first installation. However, if such a change is needed, please note that
sometimes Windows-NT 4.0 will stop loading and prompt you with error messages. Please note
that reinstallation on this NT hard disk may be inevitable. You have to backup your data stored in
this hard disk because it is almost impossible to revive this system unless booting up with
another hard disk. If this NT hard disk is installed with FAT16 disk format, please boot up your
system with any Windows OS. You will then be able to see this NT hard disk and retrieve any data.
However, if this NT hard disk is installed with NTFS disk format, only NTFS allow you to retrieve
this hard disk data.