Kontron CP690HS, User Manual

Page: 42 / 84

Installation CP690HS
Page 3 - 4 ID 20955, Rev. 05
P R E L I M I N A R Y
3.2 CP690HS Initial Installation Procedures
The following procedures are applicable only for the initial installation of the CP690HS in a sys-
tem. Procedures for standard removal are found in their respective chapters.
To perform an initial installation of the CP690HS in a system proceed as follows:
1. Ensure that the safety requirements indicated Chapter 3.1 are observed.
2. Ensure that the board is properly configured for operation in accordance with application
requirements before installing. For information regarding the configuration of the
CP690HS refer to Chapter 4. For the installation of CP690HS-specific peripheral devices
and rear I/O devices, refer to the documentation provided with the device itself.
3. To install the CP690HS perform the following:
1. Carefully insert the board into the slot designated by the application requirements for
the board until it makes contact with the backplane connectors.
2. Using the ejector handle, engage the board with the backplane. When the ejector han-
dle is locked, the board is engaged.
3. Fasten the front panel retaining screws.
4. Connect all external interfacing cables to the board as required.
5. Ensure that the board and all required interfacing cables are properly secured.
4. The CP690HS is now ready for operation. For operation of the CP690HS, refer to appro-
priate CP690HS-specific software, application, and system documentation.
Warning!
Failure to comply with the instruction below may cause damage to the
board or result in improper system operation.
Warning!
Care must be taken when applying the procedures below to ensure that
neither the CP690HS nor other system boards are physically damaged by
the application of these procedures.