Installation
CP690HS
Page 3 - 6
ID 20955, Rev. 05
P R E L I M I N A R Y
3.4
Installation of CP690HS Peripheral Devices
The CP690HS is designed to accommodate a variety of peripheral devices whose installation
varies considerably. The following chapters provide information regarding installation aspects
and not detailed procedures.
3.4.1
PMC Module Installation
1. Place the EMC gasket on the bezel of your PMC module.
2. Push the PMC bezel into the window of the front panel of the CP690HS and plug the con-
nectors together.
3. Use four screws (M2.5 x 6mm) to fix the board.
Figure 3-1: Installation Diagram
Note ...
Only one key is present on each carrier board, either 3.3V or 5V, depending
on the signaling used. The two PMC modules must both be set to the same
voltage, i.e. either both 3.3V or both 5V.
2
1
CP690HS Front Panel
PMC module
CP690HS
3
10mm stand-off
PMC bezel
4 *M2.5 *6mm
screws
Summary of Contents for CP690HS
