Technical data
Material
Smartphone holder:
Threaded bolt: Steel, powder-coated black
Smartphone holder, support, swivel joint and cap nut : PC-ABS
Support arm inside: Aluminum rod
Support arm outside, knurled handle: PA
Stand:
Base tube, extension tube, end tube, legs: steel, powder coated black
Threaded bolt, rivet, pan head screw, square nut: Steel, galvanised
Knurled washer: Aluminum black anodised
Clamping screw: Plastic and steel, galvanised
Floor protector, bracket, base brace, clamping piece: Plastic, black
Load capacity
Smartphones und ähnliche Geräte
Dimensions and
adjustment range
Smartphone holder: 58-84 mm
Vertical and horizontal: 180° and 360°
Foot circle: ø 700 mm
Height: 600 up to 1400 mm
Packing
61 x 94 x 581 mm
Weight
1.1 kg
Assembly
1.) Unpack and check item for damage and completeness
Smartphone holder with two pair of support brackets
Locking plate with swivel joint and Gooseneck
Stand
To set up the stand, loosen the clamping screw on the
base and move the three legs outward, reattach the
clamping screw. Good stability can be reached when
the foot circle diameter is set as large as possible.
The largest foot circle diameter is reached when the
base braces are horizontal.
The height can be adjusted through the two knurled
screws . To do this, loosen one of the two knurled
screws, set the desired position and hand-tighten the
knurled screw again.
Repeat the procedure with the second clamping screw.
Dismantling is carried out in reverse order.
!When setting the position, there is a crushing risk between the components!