Konica Minolta IP-011, Service Handbook

Page: 6 / 51

C-4 IP-011 PRINTER CONTROLLER
Safety and Important Warning Items
(2) Do not remove the main cover of the write unit. Direct exposure of the eye to
laser beams may lead to blindness.
(3) Do not turn the copier on while the write unit is not installed in its normal
position.
(4) Danger of explosion if battery is incorrectly replaced, replace only with the
same or equivalent recommended by the manufacturer. Discard used bat-
teries according to the manufacture’s instructions.
Vorsicht :
(4) Expiosionsgefahr dei unsachegemäßem Austausch der Battetie. Ersatz nur
durch denselben oder einen vom. Hersteller empfohlenen gleichwertigen Typ.
Entsorgung gebrauchter Batterien nach Angaben des Herstellers.
●
HANDLING OF MATERIALS FOR SERVICING
Caution: Drum cleaner (alcohol-based) and roller cleaner (acetone- based) are
highly flammableand must be handled with care.
When using these materials for cleaning of copier parts, observe the
following pre-cautions.
(1) Disconnect the power cord from the AC outlet.
(2) Use only a small amount of cleaner at a time and take care not to spill any
liquid. If this happens, immediately wipe it off.
(3) Perform cleaning only in an environment where sufficient ventilation is assured.
Breathing large quantities of organic solvents can lead to discomfort.
(4) Do not replace the cover or turn the unit on before any solvent remnants on
the cleaned parts have fullyevaporated.
Caution: Toner and developer are not harmful sub-stances, but care must be
taken not to breathe excessive amounts or let the substances come
into contact with eyes etc.
If this happens, immediately rinse with eye wash and plenty of water,
and consult a physician.
●
MEASURES TO TAKE IN CASE OF AN ACCIDENT
(1) If an accident has occurred, the distributor who has been notified first must
immediately take emergency measures to provide relief to affected persons
and to prevent further damage.
(2) If a report of a serious accident has been received from a customer, an on-
site evaluation must be carried out quickly and Konica Minolta Business Technologies, INC. must be
notified.
(3) To determine the cause of the accident, conditions and materials must be
recorded through direct on-site checks, in accordance with instructions is-
sued by Konica Minolta Business Technologies, INC..
●
CONCLUSION
Safety of users and customer engineers has topmost priority, ranking even higher than operability.
Safety depends on a appropriate maintenance work and is maintained by proper daily service work
conducted by customer engineers. When performing service, each copier on the site must be
tested for safety. The customer engineer must verify the safety of parts and ensure appropriate
management of the equipment.