Konica Minolta Di1610, Service Manual

Page: 20 / 187

G-4
2. PRECAUTIONS FOR INSTALLATION
2-1. Installation Site
To ensure utmost safety and avoid breakdown, the printer should NOT be used in a place:
• Where it will be subjected to extremely high or low temperature or humidity.
• Where it will be subjected to sudden fluctuations in either temperature or humidity.
• Which is exposed to direct sunlight.
• Which is in the direct air stream of an air conditioner, heater, or ventilator.
• Which has poor ventilation or is dusty.
• Which does not have a stable, level floor or where it will receive undue vibration.
• Which is near any kind of heating device.
• Which is near volatile flammables (thinner, gasoline, etc.).
• Where it may be splashed with water and electric leakage is likely to occur.
• Which puts the operator in the direct stream of exhaust from the printer.
• Where ammonia gas might be generated.
2-2. Power Source
• If any other electrical equipment is sourced from the same power outlet, make sure that
the capacity of the outlet is not exceeded.
• Use a power source with little voltage fluctuation.
• Never connect by means of a multiple socket any other appliances or machines to the
outlet being used for the printer.
• Ensure that the printer does not ride on the power cord or communications cable of other
electric equipment, and that it does not become wedged into or underneath the mecha-
nism.
• Make the following checks at frequent intervals:
✽
Is the power plug abnormally hot?
✽
Are there any cracks or scrapes in the cord?
✽
Has the power plug been inserted fully into the outlet?
✽
Does something, including the printer itself, ride on the power cord?
Use an outlet with a capacity of 110/120/127 V, or 220-240 V.