67
Settings Section
In this example, “EXT D-1.50” is set as the ID name.
1
Press the
key.
2
Press the
key twice.
“E” will appear at the cursor position.
3
Press the
key twice.
“X” will appear at the cursor position.
4
Press the
key once.
“T” will appear at the cursor position.
5
Press the
key twice.
“ ” will appear at the cursor position.
6
Press the
key once.
“D” will appear at the cursor position.
7
Press the
key once.
“-” will appear at the cursor position.
8
Press the
key.
9
Press the
key.
“1” will appear at the cursor position.
10
Press the
,
and then
key.
“.”, “5” and then “0” will appear at the cursor position.
5
.
Press the
key.
The ID name will be set for the selected memory channel.
* To cancel ID name setting, press the
key.
<Notes when Setting an ID Name>
●
The ID name will be kept even if the POWER switch is set to OFF.
●
Never press the following keys during ID name setting.
Doing so will cancel setting and activate the mode corresponding to the pressed key.
( 0-CAL , MODE , REMOTE , MR , MEMORY CH
,
)
If the
key is pressed while the
key is not held down (i.e. the ten-key is not used as alphabet key), a screen
for setting the analog display range will appear.
●
When the optional 4-Probe Expansion Board CA-B04 is used
Only one ID name can be set for each memory channel irrespective of the number of probes. (The specified ID
name will be common to all probes [P1] to [P5].)
CH01 EXT
Ad P1
[E
]
_
CH01 EXT
Ad P1
[EX
]
_
CH01 EXT
Ad P1
[EXT
]
_
CH01 EXT
Ad P1
[EXT
]
_
CH01 EXT
Ad P1
[EXT D
]
_
CH01 EXT
Ad P1
[EXT D-
]
_
CH01 EXT
Ad P1
[EXT D-1
]
_
CH01 EXT
Ad P1
[EXT D-1.50]
_
Summary of Contents for CA-100PLUS
