2.2 Unpacking
2-7
2.2.3 Taking Out Main Unit
Install the slope against the palette and move the main unit down from the palette.
1
Check that the four adjuster feet are in the top
position.
If any adjuster foot is not in the top position, move it up
by turning it by hand.
2
Press the first front side until it contacts the
stopper on the back side.
3
With the device slanted by pushing the top of the
first front panel (the bottom of the front side is
floating), pull it to remove the lower buffer
material toward you.
4
Press the back of the first front side until it
contacts the stopper on the front side.
Caution
Observe the following instructions when tilting the main unit.
•
Do not hold the bottom of the first front panel when lifting the main unit. (The panel may be
damaged.)
•
Do not tilt the main unit excessively. (The main unit may tip over, causing personal injury or
damage to the machine.)
Important
Do not remove the buffer material
(cardboard) that is taped to the bottom of the
device. When you unload the device from
the palette, remove this material.
Stopper
Important
Do not dispose of the lower buffer material.
It is used as the base of the slope.
Rear
Stopper
0404YF220A.book 7 ページ ２００９年８月２０日 木曜日 午後１時２６分
