Kongskilde SB 2005, Operator'S Manual, Page: 78 / 104

7 - MAINTENANCE
8. Remove the drain plug (5) . The plug (5) for draining
of oil is in the left-hand side of the cutter bar on the
outermost guide shoe. Allow all of the oil to drain out
of the cutter bar.
9. The drain plug has a magnet to collect metallic impu-
rities. Clean the magnetic drain plug of all metal frag-
ments or fines. Make sure that the copper washer is
not damaged.
10. Re-install the drain plug after the drainage of the oil
from the cutter bar.
NOTE: Add the new oil before you lower the cutter bar from
the wooden blocks. You can fill the cutter bar with oil faster
if the cutter bar is not level.
NOTICE: Always clean the area around the cutter bar in-
spection/fill plugs before you check the oil level to prevent
contamination of the gear oil.
ZEIL18HT00697AA
3
11. There is one inspection/fill plug (6) across the cutter
bar. Remove the plug and add the specified quantity
of
SAE 85W-140 or an equivalent gear oil.
NOTE: The oil level in the cutter bar must be correct. Do
not overfill the cutter bar. Excess oil will cause failure of the
cutter bar due to overheating. If in doubt as to the amount
of oil in the cutter bar, see Page
7-10 for instructions to
check cutter bar oil level or drain the cutter bar and fill with
correct type and quantity of lubricant.
12. Install the fill plugs (6) when the correct volume of oil
has been added to the cutter bar.
13. Lift the header to remove the wooden blocks.
14. Re-install the guide shoe (1) .
NHIL17HT00443AA
4
7-16