Kongskilde POLYVAC 30, Directions For Use Manual

Page: 5 / 16

5
Assembly Instructions -
Standard Units with Suction Flexhose
All instructions refer to Figure 2 on page 4
a: Rotate the Cyclone Inlet (Item A) for the best work -
ing position of the Suction Flex hose. Loosen, but
do not remove, the clamps on both top and bottom
of the cyclone. Rotate the cyclone to the desired
position, retighten the clamps.
b: Install the 4" Suction Flex hose. (Item C) First the
OK160 (6") to OK100 (4") adapter (Item B) must be
clamped to the cyclone. The Flex hose is then con -
nected with the OK100 (4") quick clamp.
c: Install the Suction Wand (Item D) to the Flex hose.
Make sure the air intake and handle are located at
the end nearest the hose.