Konami EVILNIGHT, Operator'S Manual

Page: 18 / 53

16
5 PCB settings
I/O CHECK
Checking the controls
5-3 Mode descriptions
The original factory settings are displayed in green; the changed settings are
displayed in red.
·Press the 1P start button to select a setting to be modified. Pull the 1P gun trigger
to change the setting.
·After the setting has been changed, select “SAVE AND EXIT” and pull the 1P gun
trigger.
“NOW SAVING” will appear, the modified settings will be saved, and the screen
returns to the main menu.
·If “EXIT” is selected after the modification of the settings, the following message
will appear.
“YOU DID NOT SAVE. DO YOU WANT TO SAVE? YES/NO” select “YES” or “NO”.
Press the 1P start button to select “YES” or “NO”. Pull the 1P gun trigger to enter
the decision.
If “YES” is selected, the new settings will be saved with “NOW SAVING” displayed
and the screen will return to the main menu.
If “NO” is selected, the message “NO MODIFICATION” will appear, the modified
settings will not be saved, but the main menu will show up again on the screen.
•If “FACTORY SETTINGS” is selected and the trigger of the 1P gun is pulled, all
the settings of the mode will be back to the factory ones.
MEMO
Mode for checking the performance of the controls.
To return to the main menu screen, hold down the 1P start button and pull the 1P
gun trigger.
PLAYER1 PLAYER2 PLAYER3
TRIGGER OFF OFF OFF
GUN SWITCH OFF OFF OFF
START OFF OFF OFF
SERVICE OFF OFF OFF
COIN MECH SWITCH1 OFF
COIN MECH SWITCH2 OFF
COIN MECH SWITCH3 OFF
TEST SWITCH OFF
1PLYR START AND 1PLYR TRIGGER = EXIT
I/O CHECK
•Pull each gun trigger and see if “ON” shows up in red.
•Hold the 1P and 3P gun muzzles just upward and see
if “ON” shows up in red.
Pull the 2P gun slide handle to see if “ON” shows up
in red.
•This screen is just an example.