Komatsu D51EX-24, Operation & Maintenance Manual

Page: 344 / 382

NOTICE
• Komatsu recommends using Komatsu genuine parts for replacement parts.
• If the engine is operated without the filter element, the turbocharger and aftercooler become dirty
and their performance will lower and that can cause engine problems such as overrun caused by
suction of oil. Therefore, do not start the engine without the filter element.
• The filter element cannot be cleaned. Flushing or regenerating of the filter element will degrade the
performance of the filter. As a result, the turbocharger and aftercooler become dirty and the per-
formance lowers or the crankcase pressure increases. Never reuse the filter element since it can
cause an engine failure.
• After the filter element is replaced, if KCCV is not assembled correctly, oil or blowby gas may leak.
Replace the filter element in the correct procedure.
• Always stop the engine and clean around the KCCV before replacing the element.
Prepare the special wrench for KCCV and a container to receive the oil.
1.
Remove the engine side cover (1) on the right side of the
machine.
The KCCV ventilator is located in the position shown in the
figure.
For the use of the special wrench, see the figure.
MAINTENANCE PROCEDURE MAINTENANCE
4-68