Komatsu 830E, Shop Manual

Page: 195 / 783

E02016 2/02 Electrical Propulsion Components E2-39
“8) Save Directory: . . .”
At the end of line 8) a directory is displayed for storing
the new truck configuration file. The sample in Figure
2-16 shows:
“C:\GEOHV3E\CFG\STXAPR01\TRUCK”.
This directory will be the same as the directory
shown in line A).
If the newly created configuration file is to be stored in
this directory, it is not necessary to change line 8).
When line 7) is selected and the file saved, it will auto-
matically be saved to the directory shown in line 8).
If the configuration file is to be saved in a different
directory, use the following procedure BEFORE select-
ing line 7) to save the file:
1. Move the cursor to line 8) and press [ENTER] or
press [8].
2. Type in the full DOS path name of the directory in
which to store the new configuration file. Press
[ENTER].
NOTE: If a new directory is specified, the directory
name MUST exist on the PTU hard drive. The software
is not capable of creating a new directory. New
directories must be created using DOS.
3. Move the cursor to line 7) and press [ENTER] or
press [7].
4. The current file name will appear at the end of
line 7).
5. Type in the new file name (M123131A.202 in the
example shown). The original filename will disap-
pear as the new name is typed.
6. Press [ENTER] to save the new file name into the
directory shown on line 8).
7. Move the cursor to line 1) and press [ENTER] or
press [1]. This will display the list of configuration
files as shown in Figure 2-17. Verify the new file
name has been added to the list.
8. When finished with the TRUCK SETUP CONFIG-
URATION MINE MENU , move the cursor to line
9) and press [ENTER] or press the [9] key to Quit.
a. The prompt, “Quitting, Are you sure (Y/N):”
appears as a warning against quitting without
saving the modified configuration file. Press
[Y] key if you are sure that the Mine renamed
configuration file has been properly saved.
9. The GE OHV STATEX III MENU will appear on
the PTU screen.
NOTE: It is advisable to make a backup copy (to a
floppy disk) of the current Truck Configuration File
whenever changes are made to the file. This will pro-
vide a backup copy of configuration information which
will not have to be manually re-entered in the event
data on the PTU hard disk drive is lost. Refer to the
DOS operating system manuals supplied with the PTU
for specific procedures for copying files from the PTU
to a floppy disk.
FIGURE 2-17. TRUCK CONFIGURATION FILE LIST
(Sample file name shown added to the list)