Kolver 033001, Operator'S Manual

Page: 3 / 89

Vers. 111422 3
DECLARATION OF USE
Screwdriver (class I) suitable for industrial environment only. It shall be used for
tightening. No other use will be permitted. For professional use only.
WARNING : To reduce the risk of injury, before using or servicing screwdriver, read and
understand the following information as well as separately provided safety instructions
(item code: 0MS000). The features and descriptions of our products are subject to change
without prior notice.
DECLARATION OF NOISE AND VIBRATION EMISSION
NOISE LEVEL: < 70 dB(A)
VIBRATION LEVEL: < 2.5 m/s²
These declared values were obtained by laboratory type testing in compliance with the stated
standards and are not adequate for use in risk assessments. Values measured in individual
work places may be higher than the declared values. The actual exposure values and risk of
harm experienced by an individual user are unique and depend upon the way the user
works, the work piece and the workstation design, as well as upon the exposure time and the
physical condition of the user. We, KOLVER, cannot be held liable for the consequences of
using the declared values, instead of values reflecting the actual exposure, in an individual
risk assessment in a work place situation over which we have no control.
OPERATING MODE
The screwdriver can be manual or used as fixed spindle on an automatic machine.
CONTROL UNIT
Power source by KDU-NT series.
MAINTENANCE INSTRUCTIONS
Maintenance should be performed by qualified personnel only.
•
Prior to any maintenance task: disconnect the screwdriver.
•
When disassembling / reassembling the screwdriver, take the following precautions:
-
Check that the controller is switched off.
-
Disconnect the cable.
According to Directive 2012/19/EU concerning Waste Electrical and Electronic Equipment
(WEEE), this product must be recycled.