13
Step 8: Remove Motor From Machine
Step 9: Cover Mounting End
Check
Here
1. Secure a cardboard cover to the open
mounting end of the motor.
1.
Remove the four (4) mounting bolts secur
-
ing the motor frame to the machine and slide
the motor off the shaft. The threaded holes
(M10 on C(H)09x or M12 on C(H)13x) beside
the mounting holes are provided for jacking
purposes, if necessary.
The mounting end of the motor is magnetized
and will attract magnetic material. This end of
themotor must be covered to ensure proper
cleanliness!
DDR Motor Mounting Guide | Step 8: Replace End Cover
Step 7: Replace End Cover
1. Ensure the O-ring on the outside of the end
cover is in place.
2.
Rotate the end cover until the alignment
mark matches the corresponding mark on the
housing.
3.
Secure the end cover by tightening the pan
head screws (eight (8) on the C(H)09 and
twelve (12) on the C(H)13).
