STEP 3: Wire-Opener and Stand Assembly
STEP 4: Attaching the Cage to the Cage Holder
Insert the R211 Handle Lower
Section through the R195 Wire
Opener. With the Wire Opener in
the position shown, twist the handle
90 degrees and slide the Wire
Opener up so the holes on the Wire
Opener and Handle are aligned.
Place R178 washer on one side of the
wire-opener with the flat side facing
outwards and insert R198 hex screw.
Place the second R178 washer on the
other side and tighten the R198 screw.
Fasten with R137 lock nut.
Insert R182 Cage Holder into
the handle, but DO NOT FASTEN.
Remove the lock nut from R235 Cam
and insert as shown in the above
image. Secure with the lock nut,
but ONLY FINGER TIGHT.
Fasten the Cage Holder to the handle using the
two R197 bolts and the R137 lock nut. Be sure to
insert the bolts from below with the lock
nut on top. Insert BOTH bolts and fasten hand
tight BEFORE tightening with the wrench.
Using a flat head screwdriver and pliers, fasten R227 Stand to the wire
opener using the R050 screws and R137 lock nuts. Be sure to insert the
screw from the top with lock nut underneath. Fasten tightly.
Align the holes on the ends of the cage with
the cage holder and squeeze into place.
Note the direction
of the stand
Kollectaball is a trade mark of IntoEuropeSales Ltd. Distributed in North America by RCS Sports
You are
now ready
to enjoy
your
Kollectaball!