K20s
- 53 -
§3.2.7 Radio Config
All the settings related to the radio can be done in Radio Config. There are two main settings:
Radio Parameter and Radio Frequency.
Radio Parameter
This page is mainly used to configure the parameters for internal radio module of KOLIDA
K20s.
Air Baud Rate:
This represents the data transmission rate in the air of internal radio, the higher
value, the bigger of data size transmitted per second, usually keep the default setting.
Data Baud Rate:
This represents the rate of data transmission port of internal radio, this rate
should be the same in both Base and Rover. In general, the data baud rate of KOLIDA radio
module has been unified to be 19200, keep it as default.
Channel:
This is the communication channels for internal UHF, the value of the channel must
be the same both in Base and Rover.
Power:
This appears only in Base mode, the radio transmitting power is allowed to define in
High, Middle or Low power.
Protocol:
This is radio communication protocol for data transmission, SOUTH(KOLIDA) and
TRIMTALK are optional in this page and SOUTH(KOLIDA) is the default setting, if it is
changed, Base and Rover must use the same protocol for communication.
Radio Frequency
For KOLIDA K20s, the powerful internal radio module supports much more radio channels
apply to the legal frequency in different countries or areas.
There are 120 radio channels listed in this page after clicking on radio frequency. Users are able
