Kold-Draft AKD-125, Installation And Operation Manual

Page: 20 / 32

20
INSTALLATION
NOTE:
Refer to ice cuber instructions before proceeding.
1. CAREFULLY remove the carton from the dispenser.
2. If the dispenser is to be mounted on the 6" legs provided, carefully place the unit on its back
and install the legs in the threaded mounting holes.
3.
Position the dispenser maintaining the minimum clearances specified in the cuber
instructions.
4.
Level the dispenser by adjusting the legs, or by shimming if the unit is to be sealed to the
floor. If gaps due to shims are greater than 1/8 inch, install a cove molding around the dispenser
bottom. Seal the dispenser or molding to the floor with NSF Certified RTV sealant (Dow-
Corning RTV 732 or equal).
5.
Electrical and drain locations are shown. All dimensions are in inches.