FUTURE® S AIR HANDLING UNIT
OPERATION AND MAINTENANCE
INSTRUCTIONS
15 December 2020
Ver 1.7 (We reserve the right to changes without prior notice)
8
1.6 Recycling and disposal instructions
WARNING
Observe general and section-specific safety instructions
WARNING
Before starting any disassembly work on the device, make absolutely sure that the device
is de-energised. After switching off the power, wait at least five minutes to allow
dangerous voltages to discharge from the devices.
•
Disconnect the device from other systems (ducts, heating network, cooling network, automation,
electrics).
•
If the device consists of modules, remove the module fasteners
•
Remove access doors
•
Unwire components and disconnect cables
•
Remove components
•
Disassemble modules into parts if possible
•
Sort and recycle loose parts and components according to the material recycling instructions.
The device consists of the following materials:
•
Modules: Hot-dip galvanised steel plate, mineral wool, small amounts of plastic, rubber and
adhesive mass (corner brackets, handles, hinges and gaskets).
•
Shut-off dampers: Hot-dip galvanised steel plate, polyurethane foam, small amounts of
silicone (gaskets).
•
Filters: Hot-dip galvanised steel plate, fibreglass and plastic.
•
Heat exchangers: Hot-dip galvanised steel plate, aluminium and copper.
•
Fans: Hot-dip galvanised steel plate, composite, small amounts of rubber, electric
components.
•
Switchboard: Painted steel plate
•
Electric components (field devices, wiring, central components)
•
Small amounts of plastic (e.g. pressure hoses, water traps)
Summary of Contents for Future S
Page 2: ......
