1. Mark and Drill the Mounting Holes
Measure 35-15/16
″
(91.3 cm) (dimension
″
A
″
) from the
back shower wall (not receptor edge)
to the
front ledge of the receptor and mark on the receptor with a pencil.
Align the outside edge of the wall jamb with the mark made on the shower ledge.
NOTE:
The wall jamb must sit flat on the shower ledge. If the ledge has a curve in the corners at the side
wall, it may be necessary to shape the bottom end of the wall jamb with a file.
Using a level, plumb the wall jamb.
Mark the five wall mounting holes with a pencil.
IMPORTANT!
For ceramic tile walls, use a center punch to lightly punch the five hole locations for the
wall jamb before drilling.
Slowly drill a 5/16
″
hole at the marked hole locations.
Press and hold the legs of each wall anchor (provided) together and insert the wall anchor legs into
the pre-drilled mounting holes.
Repeat for all the wall anchors.
Thoroughly clean the ledge and wall of debris.
Repeat the above procedure for the remaining wall jamb.
Wall Jamb
Shower Base
Outside Edge
Level
Pencil
Toward Wall
Receptor Size 38" (96.5 cm) x 38" (96.5 cm)
Dimension A
= 35-15/16" (91.3 cm)
Showerhead can
be on either side.
Press and hold legs together.
Anchor
1034049-2-E
4
Sterling
