12. Finish the Installation
CAUTION: Risk of property damage.
Ensure a watertight seal on the receptor drain and overflow.
NOTE:
Follow the manufacturer’s instructions for the installation of the drain, valve trim, and
showerhead.
Connect the drain to the trap according to the manufacturer’s instructions.
Seal the holes cut in the plumbing end wall.
Install and seal all escutcheons, cover plates, or flanges.
Install the valve handles or shower control handle.
Remove the protective covering from the receptor. Clean any debris from the receptor.
Remove the protective covering from the shower nipple.
Open the water supply valves.
Check operation of each valve or control. Make any adjustments as needed.
Check the drain connection for leakage. Repair if necessary.
Run the water to flush any debris from the supply lines.
Close the shower controls.
Install and seal the showerhead flange.
Using the appropriate pipe sealant, install the showerhead.
Operate the shower controls and check operation of the showerhead.
Close the shower controls.
Hand-Held Shower Slide Bar or Hook Installation
NOTE:
Use silicone sealant when placing the anchors in the pre-cut holes to prevent leaks.
Complete the installation of the hand-held shower slide bar or wall bracket according to the
manufacturer’s instructions.
Installation of Other Accessories
CAUTION: Risk of property damage.
Do not make additional holes in the wall surround or receptor
without adding adequate sealant. Holes made to install any accessories may cause leakage. The
improper installation of accessories may void the warranty.
NOTE:
For installations with wall surrounds, install the shower curtain rod above the top of the wall
surrounds.
Install any accessories according to the manufacturer’s instructions.
Verify that any holes in the finished wall are properly sealed.
When construction is completed, check for leaks.
13. Clean-up After Installation
CAUTION: Risk of product damage.
Do not use abrasive cleaners.
CAUTION: Risk of product damage.
Do not use any acid-based cleaners on fixtures made of Vikrell
TM
.
Wipe your shower unit with a soft cloth after each use to prevent a build-up of soap and scum.
Sterling recommends the following products for regular (weekly) cleaning: Spic and Span®, Top
Job
®
, Fantastik
®
, Mr. Clean
®
, or Glass Plus
®
.
Sterling
15
1016220-2-C
Summary of Contents for STERLING 6205 Series
Page 47: ...1016220 2 C ...
