22
1365393-W2-A
Caution! Failure to remove the diverter
while drilling the holes above may
allow brick dust to enter and damage
the diverter seals.
Slide the diverter partially over the wall
plate ensuring the notches in the diverter
lines up with the notches on the wall plate
and fix temporarily in place.
Notch
Notch
Notch
Fit the clamp bracket and hose retaining
ring onto the middle bar, then screw into
the lower bar. Loosely fit the wall bracket
into the middle bar arm with the grubscrew
hole at the top.
Push the riser arm onto the middle arm.
DO NOT
install the grub screw until
step 6, as it may damage the o-rings.
Fit the overhead.
Make sure that the lower bar is pushed
fully into the diverter to engage the seal.
Failure to do so will position the wall
bracket incorrectly and may result in a
leak from around the outlet of the diverter.
Mark holes for the vertical wall fixing
bracket. Use the middle arm assembly as
a guide and ensure it is vertical.
Remove assembled bar along with diverter
and wall fixing bracket.
Caution! Be careful not to damage
seals.
Note: Spare o-rings are supplied if
they are damaged during installation.
Notch
Summary of Contents for Mira Decor
Page 39: ...39 1365393 W2 A Notes ...
