Kohler KARING 2.0 K-77780T-0, Installation Manual

Page: 44 / 73

C. Install the Electrical Service and Water Supply
D. Install the T-Bolts
Install the Electrical Service
Install the Water Service
Fig.#9
NOTE:
This product is designed for installation with the electrical supply located through the wall. Both
types are illustrated. Refer to the dimensional information for your chosen installation.
NOTE:
This product is designed for installation with the water supply located through the wall. Both types
are illustrated. Refer to the dimensional information for your chosen installation.
NOTE: A floor mounted water supply stop must be no higher than 70mm from the floor.
Install the water supply. If you are installing a floor supply, study the dimensional information illustrated
carefully.
Install two new 8mm (5/16") diameter T-bolts into the
floor flange.
Do not use white cement or high lime content cements
to install this toilet. The expansion of cement due to a
rise in temperature may make the toilet crack or cause
damage. Kohler is not responsible for any damage
caused by installation with the use of cement.
DANGER: Risk of electrical shock. For hardwire installations/through-floor electrical supply:
Connect only to a properly-grounded, dedicated 220V~, 10A, 50Hz circuit protected b y a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Earth- Leakage Circuit-Breaker (ELCB).
DANGER: Risk of electrical shock. For plug-in installations/wall-mounted electrical supply:
This product is designed only for installation with the electrical supply located through the wall ,
grounding-type receptacle which is protected by a Ground-Fault Circuit-Interrupter (GFCI). Do not
remove the grounding pin or use a grounding adapter.
DANGER: Risk of electric shock.
Disconnect power before servicing.
Follow the dimensional information exactly when installing a hardwire electrical supply.
T-Bolts
Floor Flange
1250881-T01-A 44 Kohler Co.