Kohler KARING 2.0 K-77780T-0, Installation Manual

Page: 43 / 73

Fig.#8
A. To Remove Existing Toilet
B. Roughing-In
Fig.#7
INSTALLATION
Turn off the water supply. Flush the toilet, and use a sponge to remove the remaining water from the tank and
bowl. Disconnect the supply shut-off valve (if present), and remove the old tank and bowl.
Remove old gasket from the floor and closet flange with a putty knife. Remove old T-bolts and discard them.
NOTICE: if a new toilet is not installed
immediately, temporarily stuff a rag in
the closet flange.
WARNING: Risk of electric shock.
Connect only to circuits protected by Ground-Fault Circuit-Interrupters
(GFCI s) or Earth-Leakage Circuit-Breakers (ELCB s).
Keep bath and shower away from electrical parts (such as remote controller, receptacle, audio input appara-
tus and so on).
If the socket is wall-mounted , a G FCI or ELCB protected and water proof receptacle is required.
Follow the dimensional information exactly when installing a hardwire electrical supply.
DANGER:Risk of electric shock. Disconnect power before servicing.
NOTE. This product is designed for installation with the electrical supply and water pipeline
located through the wall. It is shown in the roughing-in.
Supply Stop
Floor Flange
T-Bolts
The wall location of th e electrical supply and water
supply are interchangeable.
GFCI-Prot ected 10 A Receptacle(water proof)
Closet Flange
Kohler Co. 43 1250881-T01-A
Warning: before installation, please confirm floor and flange is connected by expansion bolt.