5. Control Unit Connections
Install the straight connector onto the control unit.
Determine the length of the electrical tubing required to run
between the faucet and the straight connector on the control unit.
Cut the electrical tubing to length (as needed).
Push the faucet lead wire through the electrical tubing.
Push the electrical tubing end into the straight connector on the
control unit and tighten the straight connector.
Connect the faucet lead wire to the circuit board. The electrical
tubing may be tied to the faucet supply hose with the cable ties
provided.
Install the 4 D-Cell alkaline batteries (provided) as shown. Note
the polarity shown on the battery holder and make sure that the
battery lead is connected securely to the circuit board.
Circuit
Board
Faucet Lead
Connection
Straight Connector
Electrical
Tubing
Battery Lead
Connection
Kohler Co.
7
1031173-2-B
Summary of Contents for K-13670
Page 31: ...1031173 2 B ...
