Kohler GM93516-KP1, Installation Instructions Manual

Page: 9 / 16

9 TT-1675 5/16
10. Install the remaining panels/doors.
10.1 Align the pins with the holes in the bulkhead
connection panel and install the rear panel
(GM93540 or GM95445) on the alternator end of
the unit. See Figure 15 (item 1).
10.2 Align the pins with the holes in the base and install
the LH alternator panel (GM93539 or GM95444)
on the nonservice, alternator side of the unit. See
Figure 15 (item 2).
10.3 Align the pins with the holes in the base and install
the exhaust panel (GM93538 or GM95443) on the
nonservice side of the unit. See Figure 15
(item 3). Attach the top of the exhaust panel to the
mounting brackets in the top rail and secure using
two wing nuts (X-276-9). See Figure 12 for more
detail.
10.4 Align the pins with the holes in the base and install
the two LH panels (GM93537 or GM95442) on the
nonservice side, engine end of the unit. See
Figure 15 (item 4, two places).
10.5 Align the pins with the holes in the base and install
the front panel (GM93536 or GM95441) on the
engine end of the unit. See Figure 15 (item 5).
10.6 Align the pins with the holes in the base and install
the two RH panels (GM93535 or GM95440) to the
service side, engine end of the unit. See Figure 15
(item 6, two places).
10.7 Align the pins with the holes in the base and install
the RH alternator panel (GM93541 or GM95446)
to the service side, alternator end of the unit. See
Figure 15 (item 7).
10.8 Position the controller panel (GM93542 or
GM95447) as shown in Figure 15 (item 8) and
attach to the mounting brackets in the top rail and
secure using two wing nuts (X-276-9). See
Figure 12 for more detail.
11. Restore the generator set to service.
11.1 Reconnect the leads that were disconnected in
step 1.6. Position the controller into the controller
panel and secure using the existing hardware and
gasket (removed in step 1.7).
11.2 Check that the generator set is OFF.
11.3 Reconnect the generator set engine starting
battery, the negative (--) lead last.