Kohler GM93516-KP1, Installation Instructions Manual

Page: 3 / 16

3 TT-1675 5/16
1.7 Remove the controller. Save the hardware and
gasket to remount the controller into the sound
shield’s controller panel later in step 11.1.
1.8 Position the generator set onto the sound shield
bases (GM93517-1 and GM93517-2). Assemble
the sound shield bases (GM93517-1 and
GM93517-2) to the generator’s skid rail and cross
piece on skid using three bolts (X-6238-11) and
three washers (X-25-37). See Figure 1.
For UMS Sound Shield Kit GM95427-KP1 Only:
Install 2 base plates (GM95428) onto the sound
shield bases.
Secure the generator set skid onto the bases
using 10 bolts (X-6238-11) and 10 washers
(X-25-37). See Figure 3, items 8 and 9.
GM93516-B
1
1. Sound shield base, rear (GM93517-2)
2. Sound shield base, front (GM93517-1)
3. Bolts (X-6238-11 qty. 3) and washers (X-25-37 qty. 3)
2
Rear (Alternator) End
Front (Engine) End
3
Figure 1 Sound Shield Base Mounting Position
1.9 Remove the end bracket cover. See Figure 2.
Save the mounting hardware and discard the
cover.
1
1. End bracket cover
Figure 2 End Bracket Cover
1.10 Remove the belt guard by removing the belt guard
brackets and hardware.
2. Construct the framework.
GM93516-B
1. Rails (GM94934 qty. 4)
2. Internal rails (GM94937 qty. 6).
Mounting brackets (GM86091 qty. 6), bolts (X-6224-20
qty. 12), and nuts (X-6210-7 qty. 12) on the top of each rail.
See Figure 12.
3. Extrusion mounting brackets (GM85876 qty. 6).
See Figure 5 for more detail.
4. Upper bulkhead (GM93567)
5. LH bulkhead (GM93569)
6. RH bulkhead (GM93568)
7. Corner extrusion mounting brackets (GM85875 qty. 4).
See Figure 4 for more detail.
8. Washers (X-25-37 qty. 2) and bolts (X-6238-11 qty. 2)
9. Washers (X-25-37 qty. 8) and bolts (X-6238-11 qty. 8)
1
7
1
2
5
6
4
3
2
2
2
2
3
3
3
3
3
7
7
7
1
2
8
9
Figure 3 Sound Shield Framework Installation
2.1 Cut foam (GM87549 or GM88912) to length and
insert into the four rails (GM94934). Save
remaining foam for later.
2.2 Secure the rails (GM94934 qty. 4) to each corner
using the mounting bracket and hardware
identified in Figure 4.
2.3 Position the internal rails (GM94937 qty. 6) at the
locations shown in Figure 3 using the extrusion
mounting brackets and hardware identified in
Figure 5.