14
115982-2-
BA
(-)
Kohler Co., Kohler, WI
D. INSTALL SHOWER ROD
The shower rod, if used, should now be installed.
Position the shower rod so the shower curtain hangs
inside the bath.
E. SHOWER DOOR INSTALLATION
Shower doors for this unit are available from the Kohler
Co. Contact your dealer for more information on shower
door availability and installation.
When shower doors are to be installed on this bath
module, follow these instructions:
1.
Make sure the shower door is the correct size at
width, height, header, and threshold.
2.
Mark the locations of the fastener holes on the bath
module columns.
3.
Carefully drill the holes into the bath module
columns.
4.
To fasten the shower door columns to the bath
module columns, install hollow wall anchors that
have a 1/8” – 3/8” wall thickness allowance. Do not
overtighten the hollow wall anchors, or
damage to the bath module may result.
12. CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, do not use
abrasive cleansers as they may scratch and dull the
bath surface. Use warm water and a liquid detergent to
clean the surface.
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in
contact with whirlpool surfaces for long periods of
time. Plaster can be removed by scraping with a wood
edge. Do not use metal scrapers, wire brushes, or other
metal tools. A powder-type detergent may be used on a
damp cloth to provide mild abrasive action to the residual
plaster.
13. CONFIRM PROPER OPERATION
A. START-UP WHIRLPOOL
Refer to Important Safety Instructions on Page 2.
Please perform the following so the owner can safely
receive the benefits of whirlpool bathing.
1.
Rotate the jets so they are facing down toward the
basin.
2.
Fill the whirlpool to a water level at least 2” above
the top of the highest jet.
Water temperature in the bath should not exceed
104
F (40
C).
Bath
Wall
2” Minimum
Water Line
Jet Trim
