Page 6
INSTALLATION INSTRUCTIONS
ENGLEFIELD
(a)
Position the wall channels on the wall. The flange with pre-drilled holes should face
inside the shower enclosure. Using a level, make sure that the channel is upright.
Mark the position of the fixing holes down the centre of the channels, then remove
the wall channels.
Drill with a 3mm bit. For other types of wall structure, alternative fixings may be
required (not supplied).
(b)
(c)
Apply silicone sealant along the length of the wall and at the bottom where the wall
channel will be placed, including the top of the tray.
(d)
Position the wall channels on the wall and install the fixing screws.
(e)
Fully tighten the fixing screws, making sure that the wall channels are upright.
(f)
2
10 mm
± 0 mm
3 mm
x4
x4
VALENCIA ELITE
Square Sliding
