Kohler Command PRO ECV630, Service Manual

Page: 136 / 152

10.12
Section 10
Reassembly
Figure 10-40. Installing Intake Manifold with Wiring
Harness.
Figure 10-41. Intake Manifold Torque Sequence.
2. Install ground terminal to the crankcase post with
a silver hex fl ange screw. Torque to 4.0 N·m (35
in. lb.) into used holes or 6.2 N·m (55 in. lb.) in
new holes . See Figure 10-42.
Figure 10-42. Install Ground Terminal.
3. Install the wire harness clip to the other crankcase
post. Torque to 4.0 N·m (35 in. lb.) into used
holes or 6.2 N·m (55 in. lb.) in new holes . See
Figure 10-43.
1
2
3
4
4. Place wire harness conduit in clip and snap clip
together.
Figure 10-44. Install Fuel Injector Retaining Clip.
3. Press the fuel injector into the fuel injector cap
until the retaining clip snaps into place.
4. Press the fuel injector into the bore in the intake
manifold and rotate to original position.
Figure 10-43. Install Wire Harness Clip.
Install Fuel Injectors
NOTE: Ensure all parts are clean, undamaged and
free of debris and make sure the electrical
connectors have the seal in place.
The O-rings and retaining clips should
be replaced any time the fuel injector is
separated from its normal mounting position.
1. Lightly lubricate the fuel injector O-rings with
clean engine oil.
2. Push the retaining clip onto the fuel injector,
aligning the clip as shown in Figure 10-44.