5.20
Section 5
Fuel System and Governor
Choke Lever Detail
Figure 5-38. Governor Used with Commercial Mower Air Cleaner.
Commercial Mower Governor
Arrangement
The Commercial Mower governor arrangement shown
in Figure 5-38 is used primarily on wide area walk
behind mower applications. The initial adjustment and
sensitivity adjustment is the same as for the standard
governor. Should the governor spring be disconnected
from the throttle lever and governor lever, reconnect it
as follows:
1. Hook the long end of the spring through the hole
in the lever from the left side.
2. Rotate the spring 180° until hooked as shown in
Figure 5-38.
3. Hook the short end of the spring into the
appropriate hole in the governor lever. Refer to
the appropriate chart in Section 11 -
“Reassembly”
of this manual for the correct hole
to use for the speed involved.
Spacer
Spring Washer
Screw
Lock
Nut
Choke Cable
Choke Lever
(See Detail at Left)
Clamp
Throttle
Cable
Spring
Bushing
Linkage
Throttle Lever
Washer
Throttle Shaft
Bracket
Spacer
Deflector
(If So Equipped)
(Place Between
Valley Baffle
and Throttle
Shaft Bracket)
Bushing
Blower Housing
Washer
Lever
Spring
Bushing
Screw and Nut
Control Lever
Control
Bracket
Washer
Choke Lever
Linkage
Spring
Clip
Locker Nut
Fuel Line
Clamp
Fuel
Pump
Fastener
Lock Nut
Fastener
Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com
