11.20
Section 11
Reassembly
Figure 11-69. Installing External Governor Controls.
3. Move the governor lever
toward
the carburetor as
far as it will go (wide-open throttle) and hold in
position.
4. Insert a nail into the hole on the cross shaft and
rotate the shaft
counterclockwise
as far as it will
turn, then torque the hex. nut to
6.8 N·m
(60 in. lb.)
.
Install External Governor Controls
1. Install the governor lever onto the governor cross
shaft. See Figure 11-68.
Figure 11-68. Install Governor Lever to Shaft.
2. Make sure the throttle linkage is connected to the
governor lever and the throttle lever on the
carburetor. See Figure 11-69.
Figure 11-71. Installing Control Panel.
8. Assemble the throttle control shaft to the control
bracket.
9. Assemble the choke control to the control bracket.
10. Connect the Oil Sentry™ Indicator light wires.
Attach governor spring to governor lever. See
Figure 11-72 and appropriate charts on pages
11.22 through 11.24.
Figure 11-70. Installing Lower Support Control
Bracket.
7. Install control panel to the blower housing if
removed previously. See Figure 11-71.
5. Reconnect the lead wire to the fuel shut-off
solenoid if so equipped.
6. Install the lower support control bracket if equipped
with a control panel. See Figure 11-70
Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com
