1212006-2A-B
2
1212006-2A-B
3
INSTALLATION CHECKOUT
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
How To Install Faucet
Use appropriate thread sealants or thread tape on pipe threads. Install the two
offset connectors(1) into the hot and cold supply pipes.
Adjust the center-to-center distance between the connectors to 150mm and
horizontally. They should extend 40 to 45mm from finished wall. Thread the
escutcheons(2) onto the connectors until they contact the finished wall.
Put the washers(3) into the nuts(4). Thread the nuts onto the connectors(1) and
tighten by wrench.
How To Install The Handspray
Remove the guard on the outlet connector firstly.
Put the washer(5) into end A of the hose(6), and then connect to the faucet
outlet(7). Put the washer(8) into end B of the hose, and install the check
valve(9) into the handspray(10) inlet if needed, then connect end B of the hose
to the handspray inlet.
3
10
4
1
2
8
7
9
B
5
A
6
How To Install The Bracket
Determine a suitable location on the finished wall to install the bracket. Mark
bracket base mounting hole locations on the wall according to the dimension.
Drill two holes on the finished wall, the holes should match the anchors(11).
Install the anchors.
Tighten screws(12) to secure bracket base(13, flat side upward). Put the
bracket(14) onto the bracket base and lock by stopper.
150mm
40~45mm
Hot
Cold
Ensure that all coupling nuts are tight.
Ensure that the handle is in the off position.
Turn on the main water supply, and check for leaks. Repair as needed.
72282T-4: Bath Shower Faucet
Remove the handspray(10). Remove the aerator(15) by coin. Run hot and cold
water through the faucet for about one minute to remove any debris. Check for
leaks. Remove any debris from the aerator assembly. Shut the faucet off, and
reinstall the aerator assembly and handspray.
72351T-4: Shower Only Faucet
Remove the handspray(10). Run hot and cold water through the faucet for
about one minute to remove any debris. Check for leaks. Shut the faucet off,
and reinstall the handspray.
10
15
10
27
12
14
13
11
