DO NOT operate the product if water is leaking from inside the valve module. Isolate electrical and water supplies to the
product and refer to the fault diagnosis section.
DO NOT operate the product if it is thought to have been exposed to freezing conditions. Isolate electrical and water
supplies to the product and contact Customer Service.
Verify that you fully understand how to operate this shower and verify that it is properly maintained in accordance with
the instructions given in this guide.
This product can be used by children aged from 8 years and above and persons with reduced physical, sensory, or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of
the appliance in a safe way and understand the hazards involved.
DO NOT allow children to play with the product.
DO NOT allow children to clean or perform any user maintenance without supervision.
Children under 8 must be supervised when bathing or showering.
The water temperature needs to be set at a suitable temperature (body temperature is approximately 38°C). Babies and
Children are more sensitive to temperature than adults and it is recommended to check that the delivered water
temperature is less than 38°C.
The maximum mixed water temperature from the product is 48°C to take into account losses in metal baths. It is not a safe
bathing or showering temperature.
Always check that the water temperature is safe before bathing or showering.
DO NOT remotely operate or alter any of this product’s shower and bathing settings if it is already occupied and / or
being used by another person.
DO NOT use excessive force when making connections.
Avoid layouts where the shower hose will be sharply kinked. This may reduce the life of the hose.
The position of the shower fittings must provide a minimum air gap of 25 mm between the handshower and the spill over
level of any bath, shower tray, or basin. There must be a minimum distance of 30 mm between the handshower and the
spill over level of any toilet, bidet, or other appliance with a Fluid Category 5 Backflow risk.
DO NOT operate the valve at voltages other than that stated on the rating label.
This appliance is only to be used and supplied at SELV (Safety Extra Low Voltage) using only the supplied detachable
power supply unit.
The supply cord of the power supply unit cannot be replaced. If the cord is damaged, the power supply must be replaced.
In the event of a cold water failure, the product is designed to reduce the flow. Depending on the temperature of the hot
water, the valve may shut down to prevent scalding.
Recommended Usage
Domestic
Yes
Light Commercial
No
Kohler Co.
3
1430528-W2-
A
