Kofloc EX-700R, Instruction Manual

Page: 18 / 25

MJ400271F1
- 17 -
7-5.
【
Parameter setting mode
】
When an instantaneous flow rate is being indicated, pressing and holding DISP key [
□
] sets the parameter setting
mode. Each time DISP key [
□
] is pressed, the indication changes in the order of mode No.
→
set value
→
mode
No.
→
set value.
To change the set value, use the UP key [ ] or DOWN key [ ]. When the UP key [ ] or DOWN key [ ] is
pressed and held, the digit can be shifted.
After setting a parameter, pressing and holding DISP key [
□
] registers the set value and returns the mode to
the flow rate indication mode.
①
Default values
A B C D
F-00
※ ※ ※ ※
P-00
※
P-01 1
P-02 3
P-03 3
P-04 0
P-05 0
P-10 0 0
P-11 9 9 9 9
P-12 9 9 9 9
P-13 3 0
P-14 9 9 9 9
P-15 9 9 9 9
P-16 0 1 0
P-20 0 0
P-21 9 9 9 9
P-22 9 9 9 9
P-23 3 0
P-24 9 9 9 9
P-25 9 9 9 9
P-26 0 1 0
P-30 1
P-31 1. 0 0 0
P-40 1
P-41 2
P-42 0
OUT2 instantaneous flow rate lower limit p reset setting
OUT1 instantaneous flow rate lower limit p reset setting
Dead time value
OUT1 integrated flow rate reach preset setting up per 4 digits
OUT1 integrated flow rate reach p reset setting lower 4 dig-its
Integrating pulse output rate
Parity
Dead time value
Applicable gas selection
CF value
Communication ID
Integrating pulse output rate
Transmission speed selection
OUT2 integrated flow rate reach preset setting up per 4 digits
OUT2 integrated flow rate reach p reset setting lower 4 dig-its
Low cut function selection
Mode No.
Default Value
Set Item
Indication of max. value (unchangeable)
Reference condition on flow rate
PV filter
Instantaneous flow rate indication update cycle
Integrated flow rate hold selection
OUT1 output selection
OUT1 instantaneous flow rate up per limit p reset setting
Analog output selection
OUT2 output selection
OUT2 instantaneous flow rate up per limit p reset setting
※
According to the ordered specifications.