VRS Installation Guide
29
Appendix A
Kofax Product Installation Guideline
Installation Scenarios
You may install VRS 3.5 in conjunction with other Kofax products, except as follows:
VRS 3.5 should not be installed on a system with Hardware VRS versions 1.02, 1.03,
1.04, and 1.05. To ensure optimal VRS performance, refer to the documentation that
accompanied your other Kofax product(s) for specific recommendations.
If you are currently running VRS 2.0 or later, you can successfully upgrade to VRS 3.5
without removing your existing application. If you are currently running VRS 1.02,
you must upgrade to VRS 2.0 before upgrading to VRS 3.5.
If you are currently running Hardware VRS 1.03, 1.04, or 1.05, you are required to
remove all instances of Hardware VRS prior to installing VRS 3.5. Additionally, you
are required to use the VRS upgrade kit to update your installation to VRS 3.5.
For more information about removing VRS, refer to
VRS Removal Procedures
on
page 27.
Ascent Capture
If you are installing Ascent Capture, refer to the installation documentation that
shipped with Ascent Capture.
Other Kofax Products
A good resource for the installation of Kofax products is the Scanner Configurator on
the Kofax Web site. The Scanner Configurator can be used to determine if a particular
combination of Kofax products is recommended. The Scanner Configurator does not
list installation order, however. Again, refer to the documentation that accompanied
your other Kofax product(s) for installation instructions. See
Technical Support
Information
on page viii for information on how to contact Kofax if you need
assistance in determining installation order.
