-7-
6. WIRING
6-1 Power and operation signals
Open terminal cover (side cover). There is a terminal block (6P) for wiring. (See Fig.6)
[Fig.6]
a) Wiring work should be made by a qualified engineer in accordance with electrical technical
standards.
b) Do not make wiring work in the rain or high humid conditions.
c) Make proper wiring referring to the wiring diagram.
d) For all connections use fork crimped-on terminals.
e) Use a cable of outer diameter
φ
9~11mm for standard conduit (See Fig.7) .
When using a customer conduit, select a proper size one to fit cable diameter, as otherwise, it may
cause troubles due to water ingress etc.
f) After wiring is completed, screw up terminal cover and conduit, or it may cause troubles due to
water ingress etc.
CAUTION FOR WIRING WORK
Seal Tight Device
Cable outer diameter
φ
9~
φ
11
Seal
1/2”NPT
Actuator body
[
Ｆ
ig.7]
O-ring
Screw for cover
Wire inlet
(conduit)
Terminal (6P)
Terminal block
