12
A-61514 September 2004
Making connections
Follow the instructions for installing the IEEE-1394 (FireWire) card and the
Kodak
Driver Software before you plug the scanner into the host computer.
IMPORTANT: You must install the software on the host computer before you
install the scanner.
Installing the IEEE-1394
(FireWire) card in the
host computer
An IEEE-1394 six-pin connector is provided on the rear panel of the scanner
for IEEE-1394 (FireWire) connectivity.
1. Install the IEEE-1394 (FireWire) card in the host computer as described by
the instructions included with the card.
WARNING: Installation of the connector in the wrong orientation will
damage the scanner and IEEE-1394 FireWire card.
IMPORTANT: Use proper precautions to avoid static when you install the
IEEE-1394 (FireWire) card in your computer.
2. Power up the host computer after the IEEE-1394 (FireWire) card
installation is complete.
Installing the
Kodak
Driver Software
1. Insert the
Kodak
i100 Series Installation CD in the CD-ROM drive.
The installation program starts automatically.
2. Follow the on-screen instructions to install the TWAIN and ISIS drivers and
the
Kodak
Scanner Validation Tool.
Installing the IEEE-1394
(FireWire) cable
1. Attach the end of the IEEE-1394 (FireWire) cable to the IEEE-1394 port on
the back of the scanner as shown.
2. Attach the other end of the IEEE-1394 (FireWire) cable to the
host computer.
WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable
connector end correlates to the IEEE-1394 port configuration
before you plug the cable in. Damage to the scanner will
occur if the cable is attached in the wrong position.
IMPORTANT: The i100 Series Scanner should be the only item plugged into
the IEEE-1394 (FireWire) card on the host computer.
