KOCOM KCV-T701SM, Manual

Page: 4 / 28

4
■Door camera installation
KC-MC24(D1)·KC-MC24M
Wall
Screw
(4X16mm)
Camera
front
Screw
(4X10mm)
After fix the rear bracket with 4 screw, put the Door Camera into the grooves of rear bracket,
and then fix it with hexagon screws and stick the finishing materials.
※
Installation Location
■ Monitor installation
■Directly connecting cut-off power cord with power wire
1) Personal electrical work must be avoided. Please find local installer or electrician for installation.
2) power cords must be insulated with insulation tape after the work.
[Exposed wires may cause fire or electric shock.]
3) Highly recommend to cut main power supply off before electrical work.
1) Remove metal wall hanger bracket behind monitor.
2) Install metal wall hanger bracket on 1 type box or wall with attached screw.
3) Connect wiring to monitor back terminal referring to product connection diagram.
4) Hang monitor on metal wall hanger bracket
5) Test the product status if the monitor is both plugged in and switched on.
■ Caution of camera installation
·Avoid installing camera exposed to direct sunlight or lights.
·Back light or shadow on visitor's face may occur difficult recognition.
·Avoid installing camera in places such as the following picture.
(1) Place illuminating sky as background
(2) Place with white wall reflecting direct ray of light
(3) Place with direct ray of light
■ Camera installation location
·Recommended installation
height of door camera is
where lens is about 1,400mm
above the floor. In this case,
camera stack center (Buried
box) is above 1,390mm
above ground level.
■ Monitor installation location
·Recommended installation
height is about 1,500mm
where screen center is at
eye level. In this case,
wall - hanging metal center
(center of piping) is 1,450mm
above ground level.
KC-S81M(D1)·KC-S81M2
Wall
Screw
Flush
mount
bracket
Main
body
Sun
visor
Wall
Wall
KC-MC20(D1)·KC-MC20M
Flush
mount
bracket
Main
body
Main
body
Sun
visor
Sun visor screw
2X4(3EA)
Angle
supporter
Screw cover
(2EA)
Screw cover
(2EA)
Main body screw
4X18(2EA)
Surface mount type
Surface mount type
Flush mount type
Main body screw
4X18(2EA)
Bracket screw
4X25(2EA)
Bracket screw
4X25(2EA)
※When using angle supporter,
if main body screw(4X18) does not fit, please use spare screw(4X20)
KC-MC30M(2M,AHD)
Wall
4X25mm
Screw
4X8mm
Screw
Rear Bracket
Camera front
Wrench
Name plate
KC-Q81P(D1)
Screw
Rear bracket
Camera front