1
When the picture is too bright
- Please check if the monitor’s brightness control is get too high.
- Please check if the camera is set to BLC ON under normal lighting
conditions.( i.e. when the camera is not pointed towards a brightly lit area)
Please move the BLC select switch to the BLC OFF position.
When there is noise on the picture in dark illumination conditions
- The camera picture becomes noisy under AGC MAX mode in order to
increase the video gain in poor lighting conditions. Please move the AGC
switch to OFF position if it is not required.
When the picture is not clear on the monitor
- Please check if the monitor is set up correctly.
- Please check if the camera is pointer towards an area where too much
light comes in. Adjust the direction of the camera in this case.
- Please check if the back focus of the lens is set correctly.
When the picture is flickering
- Please check if the camera is pointed at fluorescent lighting or bright
sunlight. Use a visor or adjust the direction of the camera in this case.
- Please check if the Auto iris lens is selected correctly on the IRIS mode
select switch. Please move the Iris mode switch to DC position when you
use a DC type auto lens or move it to the VI position when you use a
Video type auto iris lens.
- When you don't use an auto iris lens, please move the iris select switch to
the ES position
When the picture is distorted
- Please check if the lens is defective and replace the lens in this case.
- Please check if the camera is PAL/CCIR(50Hz) in an NTSC/EIA(60Hz)
area or vice versa.
21
22
N o t e
