KSK
page 6
KSK
01
/0322
7.2. Electronic Contact (option)
Make sure that the supply wires are de-energized.
Loosen the plug-cap holding screw and remove the cap from the switch
housing.
Connect the supply lines inside the plug-in accordance with the connection
diagram opposite.
If the set point has not yet been adjusted, it may be done at this point. (see
section 8. Operation).
Set the plug to the socket and fix it with the safety screws.
Attention! The stated electrical parameters of the contact may not
be exceeded. For inductive or capacitive loads, we recommend the
use of contact protection measures respectively the application of a
contact protection relay.
After connecting the external devices, and adjusting the switch housing to the
desired switch points, all the connection work is completed. The unit is ready for
operation.
Signal max. 100mA
LED
+V
S
GND
R
L
