5020-M Owner's Manual
Kobelt Manufacturing Co. Ltd.
rev B
mnl5020-M.docx
19 of 27
1.
Remove bottom cotter pins from pins ‘E’.
2.
Remove pins ‘E’ by
pulling upwards.
3.
Remove shoes by sliding radially forward to clear the ends of the levers.
When re-installing the shoes into the caliper assembly, be sure to re-engage the balancing
links “A”
If there is insufficient room radially to remove the shoe, th
en screws ‘C’ must be removed.
6.3.2.2
Balancing Link Adjustment
Figure 4: Balancing Link Adjustment Reference Diagram
To adjust:
1.
Loosen screws ‘B’,
2.
Apply brakes onto the disc,
3.
Ensure link ‘A’ has no tension on it
. Adjust if necessary.
6.3.2.3
Reinstalling the Shoes and Pivot Blocks
When reinstalling the shoes and pivot blocks reinstall the shoe pin first to align the pivot
blocks before tightening screws ‘C’
.
Tighten screws ‘C’ to the value given in the table below.
Table 5: Pivot Block Screw Torque
Caliper Model
Bolt Size
Torque
5020
3/8 UNC
201 in-lbs [22.7 Nm]
