5020-M Owner's Manual
Kobelt Manufacturing Co. Ltd.
rev B
mnl5020-M.docx
18 of 27
Table 4: Brake Disc Minimum Thickness Allowances
Brake Disc Minimum Thickness
Disc Series
Original Thickness
in [mm]
Minimum Thickness
in [mm]
1.25-2.5-XX
1.25 [31.8]
1.18 [30.0]
When re-machining the disc surface, equal amounts must be taken
off of each face.
6.3
S
ERVICE
6.3.1
Lubrication
All Kobelt calipers, during assembly, are pre-greased on the shoe pin and saddle pin with a
Lithium based NLGI 2 grease. These pins must be re-greased no less than once annually.
6.3.2
Brake Linings
The linings must be replaced before the rivets make contact with the disc. Remove worn
linings from the shoe by drilling out the rivets with a ¼” drill
. Install new linings with the
proper rivets.
6.3.2.1
Lining Replacement
Figure 3: Lining Replacement Reference Diagram
Follow the following steps to replace the lining:
