REPLACING THE TOOTH POINTS
When replacing the tooth points or the side cutters, contact our authorized dealer/distributor.
When hammering, metal chips can fly. If it flies into the eye, it may result in severe injury. Wear
protective gears such as protective glasses, hard hat and gloves.
REMOVING THE TOOTH POINT
1. To hammer out the tooth pin, place the
bucket on safety block (6), making the tooth
parallel to the ground.
2. Using hammer (7) and punching tool (8),
hammer out locking pin (4). Be careful not to
break rubber lock pin (3).
3. Inspect locking pin (4) and rubber lock pin
(3). If locking pin (4) is too short or rubber
lock pin (3) is in poor condition as shown to
the right, replace it with a new one.
6
7
8
2
INSTALLING THE TOOTH POINT
1. Push rubber lock pin (3) into the hole of the
adapter nose.
2. Fit tooth point (2) onto adapter nose (5).
3. Hammer locking pin (4) until it is aligned with
the point surface.
3
2
4
1
2
3
Align the rear face of the pin bore on the tooth point with that on on the adapter nose or insert the
tooth point more deeply.
[
4. MAINTENANCE
]
4
4-
27
Copyright©2019 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2PS00017ZE08] [1226CsCshWbYs]
