KDH-BAT
Smoke Alarm
www.grupotemper.com
*Standard/Flathead screwdriver
*Hammer
1.
Hold base firmly and push the hinge in then turn anti-clockwise,so release the base down.
2.
Hold the smoke alarm base against the ceiling(or wall) and make a mark at the center of each of the mounting slots with
a pencil.
3.
Place the unit where it won’t get covered with dust when you drill the mounting holes.
4.
Using a 6.5mm drill bit,drill a hole through each pencil mark into 35mm deep.
5.
Insert the plastic screw anchors into the holes and tap them gently with a hammer.Tighten the 3*30 screws into the screw
anchors,then loosen them two turns.
6.
Slide the smoke alarm base up to the screw heads end up in the narrow ends of the mounting slots, then tighten the
screws completely.
7.
Insert the 9V battery into the the box, make sure the red pry is under the battery,so the battery is stable. Diagram 3.
DIAGRAM 4
8.
Ensure to insert battery before you install the alarm,
or you will destroy the unit.
9.
Close the cover with the alarm according to
Diagram 4,and then finish your installation.
TEST
It is important to test this unit weekly to make
sure it is working properly. Don’t open the alarms
by yourself, return them to the seller if improperly,
and don’t use fire to test your alarms.
1.
Press and hold the test button on the cover of the
unit until the alarm sounds. If it does not alarm,
make sure that the unit is receiving power and test it again. If it still does not alarm,
replace it immediately or check your battery.
2.
The signal flashes once 30 seconds and while it alarms the signal will flash once 0.5 second.
3.
If the alarm makes low “chirp” sounds every about 30seconds,it tells you to exchange your battery.
4.
Little smoke will not cause alarms, so misinformation occurs only when you blow smoke to the alarms directly or you
forget to turn on your ventilated facility while your cooking.
5.
Sometimes when you smoke the unit will alarm, so you can just blow air to it to stop alarming.
DIAGRAM 3
9V
ba
tte
ry
9V
ba
tte
ry
+
-
+
-
PUSH