9
ET2 lever
MENU08：Steering sub trim
+ key
− key
L25 〜 0（Default setting） 〜 R25
▶This function allows you to adjust the edge of operation
and neutral position at the same time.
(Use when installing servo and test running)
MENU11：Throttle trim
+ key
− key
b50 〜 0（Default setting） 〜 F50
MENU09：Steering reverse
+ key
− key
REV（Default setting）／ NORM
▶This function allows you to change the direction
of servo movement
(Use this function when the turning direction of servo
is opposite to the transmitter operation)
※
REV：
Reverse
NORM：
Normal
MENU10：Throttle monitor
Neutral position
▶Displays current throttle position.
▶Adjust neutral position of throttle while running
■MENU 08〜11
If throttle direction is in reverse position, throttle movement
and F/b indication of monitor will be reversed accordingly.
Adjust "MENU02: Steering trim" to adjust neutral position only.
When value of the sub trim gets bigger, adjust the linkage and
make it a smaller the value. In certain circumstances, too big
value may cause dead area (servo does not react) at the edge
of operation.
In general, trim adjustment is not required when using with
electric car with preset electronic speed controller (ESC).
The position of the end point does not move. Only the neutral
position moves.
When changing the edge of movement, adjust in "MENU17:
Throttle sub trim".
Throttle trim can also be adjusted by using ET2 lever.
＋/− keys. Push both keys together to reset.
Adjust using
＋/− keys. Push both keys together to reset.
Adjust using
＋/− keys. Push both keys together to reset.
Adjust using
