o
Install cover on top of the bus terminal so that it snaps into place (figure 6).
Removing the cover
Figure 7: Removing the cover
o
Press the cover to the side and pull it off (figure 7).
5.2 Commissioning
Measuring the hanging and slat operation time
The blind/shutter travelling time is important for position and scene runs. For slatted Venetian
blinds the slat adjusting time is by design part of the overall blind/shutter travelling time. The
opening angle of the slats is therefore set as the operation time between the positions Open
and Closed.
The upwards travel generally lasts longer than the downwards travel, and is taken into account
as the operation time extension in %.
o
Measure upwards and downwards operation time of the hanging.
o
Measure slat adjusting time between Open and Closed.
o
Enter the measured values in the parameter setting – Downwards travel in seconds and
operation time extension in percent.
i
In the case of automatic operation time detection, no measurement of the hanging
operation times is performed.
i
Automatic measurement of the slat adjusting time is not possible.
Load the address and the application software
o
Switch on the bus voltage.
o
Assign physical addresses and load application software into the device.
o
Note the physical address on the device label.
6 Appendix
6.1 Technical data
Supply
Rated voltage
AC 230 / 240 V ~
Mains frequency
50 / 60 Hz
Power loss
Art. No. 2304.16 REG HE
max. 2 W
Art. No. 2308.16 REG HE
max. 3 W
Art. No. 2316.16 REG HE
max. 4.5 W
Ambient conditions
8/11
82560023
J:0082560023
05.08.2013
Switch actuator / blinds actuator
